The EU-funded RES4BUILD project is developing integrated renewable energy-based solutions that are tailored to the needs and requirements of users and installers. The project aims to increase the uptake of renewable energy solutions for heating and cooling; decarbonising the energy consumption in buildings and contributing to EU energy and climate goals.
The consortium is working to improve the performance and reduce the cost of the most innovative components of the RES4BUILD solutions – by integrating photovoltaic thermal (PVT) collectors, magnetocaloric and multi-source heat pumps, optimising their performance through advanced control and building energy management systems. The developed solutions will be validated in different regions, paving the route to the market and ensuring wide adoption.
Much progress has been shown to date, with work on the main components well-underway. RES4BUILD partners MG Sustainable Engineering AB and the University of Gävle, both from Sweden, are constructing the novel concentrated PVT collector with a new reflector geometry. The prototype collectors, which provide both heat and electricity from the same area, will be tested from this summer both in Sweden and Greece to collect data from two different climatic zones.
The configuration and design of the multi-source vapour injection heat pump has also been finalised using a low-GWP refrigerant (an HFO: R1234ze(E)). A Greek Supplier (Kontes S.A.) along with Honeywell supported the heat pump activities of RES4BUILD by providing at no cost the required quantity of refrigerant to Psyctotherm. It is supplied with the most optimal heat either from the outside air, from the PVT collectors or from the ground. The control unit is designed in a way to allow communication with the RES4BUILD building energy management system. A prototype of this heat pump has been manufactured by the project partner Psyctotherm and installed at NCSR Demokritos for lab tests and characterisation. Initial tests already show a coefficient of performance (COP) of over 5. In August, the heat pump will be shipped to DTI in Denmark to become a valuable part of the integrated pilot system, which will be tested later in the project.
In parallel to the technical work, JIN and BAPE are working with end-users and other stakeholders on six case studies in the Netherlands and in Poland aiming to devise a best practice approach to renovations of energy systems in a more integrated and systematic way, resulting in more efficient operation and optimised interaction with the grid, and thus a lower energy bill for European consumers. The co-design approach will assist with social inclusion and ultimately contribute to an accelerated energy transition, in line with European Green Deal objectives.
For more information on the project and more regular updates, please visit the project website at www.res4build.eu or follow the project on Twitter @RES4BUILD.
The RES4BUILD project has received funding from the European union’s Horizon 2020 research and innovation programme under grant agreement no. 814865. RES4BUILD – “Renewables for clean energy buildings in a future power system” will run for four years, from 2019 to 2023.
ERINN Innovation are leading WP8: Communication, Dissemination, Knowledge Transfer and Exploitation.
Image (c) MG Sustainable Engineering